Primary process: Laser Cutting. The full route, materials, tolerances and design tips for a logo, with an indicative cost.
Laser CuttingPrimary process
Non-traditionalFamily
4Route steps
+/-0.1mmTypical tol.
A logo is primarily made by Laser Cutting. Laser cutting focuses a high-power beam to melt and blow through sheet, cutting intricate flat profiles quickly with a narrow kerf. Below is the full route to make a logo, the materials it suits, the tolerances to expect and the main design points. The route is free, from the finder.
Step by step
How a logo is made
The usual route, raw material to finished part. The amber step is where the logo gets its basic shape.
Stock
Prepare the conductive or sheet stock for the logo.
Laser Cutting
Cut the logo to its precise profile with no mechanical force.
Tooling None Tolerance ±0.05 to 0.2mm Lead days
Deburr and finish
Remove the recast layer or edge burr and finish as needed.
Inspection
Check the profile and surface against the drawing.
Need the real cost for a logo? The free route above is yours. Unlock the full dossier to quote and source it.
Where this process typically lands. Tighter is possible with extra operations like grinding, at higher cost.
Materials
Materials for a logo
Grade
Why it suits this
Mild steel
Cheap, cuts fast
Stainless 304
Clean edge (N2)
Aluminium
Reflective, needs power
Design
Design tips
General pointers. The full design-for-manufacturing list for a logo is in the dossier.
Features smaller than material thickness.Size features >= thickness.
Sharp inside corners.Add small radii / dog-bones.
Cost
What a logo should cost
Fast flat cutting in sheet/plate; no tooling, priced by cut length and material. Great from qty 1.
PER-PART COST vs VOLUME
Per-part cost drops as volume spreads tooling and setup over more parts. The exact figures for a logo at your volume, in your currency, are in the dossier.
MODEL EST.
$3.8 to 11per part at 1 off
A rough ballpark only. The dossier gives should-cost at your exact volume and currency, with the full breakdown.
GET THE FULL DOSSIER
Everything you need to quote and source it
The free route above is yours. To actually put a number on a logo and buy it well:
Should-cost at your exact volume in 12 currencies, with the material, processing, tooling and overhead breakdown
Who to source from, typical MOQ and lead time, and the exact RFQ checklist to send
A quote checker that tells you if a supplier quote is fair, and the red flags to watch
SistematikWork is a whole IE platform. Past the free finder, there are 41 ready Excel calculators, templates and CAD guides, each built from real coursework and checked against known values.
Manufacturing & OperationsQuality & ReliabilitySupply ChainProject & StatisticsEngineering Career
A logo is primarily made by laser cutting. The route is: Stock; Laser Cutting; Deburr and finish; Inspection.
What does a logo cost?
It depends on size, tolerance and volume. As a rough ballpark it starts around $3.8 to 11 per part at 1 off and falls with quantity. The dossier gives should-cost at your exact volume and currency. A model estimate, not a quote.
What material is a logo made from?
Common choices are Mild steel; Stainless 304; Aluminium.
What is the main process for a logo?
Laser Cutting. Flat sheet parts with fine detail, prototype to high volume, in most metals.
See the exact route and should-cost for your part
The free finder maps your part to its process and full route. Pro adds should-cost at your volume, sourcing and an RFQ draft.
